Orange PI Plus - reset EMMC flash

Lucalee65 · Published in 2015-10-3 17:55:36

Edited by Lucalee65 at 2015-10-3 18:04

Hi,

I'm a problem with my pi plus: I've installed android in EMMC flash memory but I want to change with Ubuntu.

The problem is that in the microsd I've have ubuntu but, during the bootstrap Orange load only nand flash with android.

The question: It's possible to reset EMMC flash?

Thank in advance

Luca from Italy

jackblues · Published in 2015-10-9 20:25:52

hi luca, this is Jackblues from Spain

i have a question for you. how do you do to install android into nand?? i' trying do it on my OPI+ but i don't know how.
thank you in advance

Lucalee65 · Published in 2015-10-10 23:45:33

Edited by Lucalee65 at 2015-10-10 23:48

Hi Jackblues

I've used Win32DiskImager-0.9.5 and a image of android download from orange site.

then, in automatic, I've found android into nand and now I can't install other os...

loboris · Published in 2015-10-11 00:27:57

To install Android image to emmc, you must use PhoenixSuit.
You can use those instructions.
To enter upgrade (FEL) mode, connect USB cable to OTG port, press the upgrade button and power on.

jackblues · Published in 2015-11-7 06:56:01

loboris replied at 2015-10-11 00:27
To install Android image to emmc, you must use PhoenixSuit.
You can use those instructions.
To enter ...

thank U so munch... I thought that I was crazy.

lost66 · Published in 2015-11-7 22:09:28

What do you mean by OTG port? And what cabel should it be? Connected to where? If I have system on sd and I want to install it on flash how should I do it ?

jackblues · Published in 2015-11-8 06:09:54

lost66 replied at 2015-11-7 22:09
What do you mean by OTG port? And what cabel should it be? Connected to where? If I have system on s ...

it's the USB OTG port (mini usb port besided sd). you should use one "usb A female to mini usb male" to conect standard usb (male to male) with a computer who have a phoenixsuite to write the O.S. into nand.

in other way, i'm trying to do it but something goes wrong with phoenix suit (v1.0.7)

it starts to upgrade nand and shows 10%, but 35 minutes after still at the same 10%
which may be the fault??

thanh_tan · Published in 2017-5-18 02:02:24

Hello,

I have the same problem as you

I have install the Armbian on eMMC and now i want to change it to Raspbian. However, while i flashed the microSD card to Raspbian , inserted to the Orangepizeroplus, it always boot with Armbian