|  | 
 
| Hi, I want use 4 TB sata disk on orange pi plus 2. But I could not use because of orange pi plus 2 dont know it correctly.
 Orange pi plus 2 see, 2 TB instead of 4 TB like as;
 Disk /dev/sda: 1.7 TiB, 1801763772416 bytes, 3519069868 sectors
 
 [    2.640845] scsi 0:0:0:0: Direct-Access     ST4000LM 016-1N2170       0009 PQ: 0 ANSI: 0
 [    2.642564] sd 0:0:0:0: [sda] 3519069868 512-byte logical blocks: (1.80 TB/1.63 TiB)
 [    2.643582] sd 0:0:0:0: [sda] Write Protect is off
 [    2.643599] sd 0:0:0:0: [sda] Mode Sense: 03 00 00 00
 [    2.644653] sd 0:0:0:0: [sda] No Caching mode page found
 [    2.644667] sd 0:0:0:0: [sda] Assuming drive cache: write through
 [    2.648018] sd 0:0:0:0: [sda] No Caching mode page found
 [    2.648032] sd 0:0:0:0: [sda] Assuming drive cache: write through
 [    2.679655]  sda: unknown partition table
 [    2.682941] sd 0:0:0:0: [sda] No Caching mode page found
 [    2.682962] sd 0:0:0:0: [sda] Assuming drive cache: write through
 [    2.682980] sd 0:0:0:0: [sda] Attached SCSI disk
 
 
 But it should be(i test it on bananapi);
 
 Disk /dev/sda: 3.7 TiB, 4000787030016 bytes, 7814037168 sectors
 
 [    2.229797] sd 0:0:0:0: [sda] 7814037168 512-byte logical blocks: (4.00 TB/3.63 TiB)
 [    2.241803] sd 0:0:0:0: [sda] 4096-byte physical blocks
 [    2.251081] sd 0:0:0:0: [sda] Write Protect is off
 [    2.380451] sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
 [    2.419335] sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
 [    2.665622]  sda: sda1
 [    2.681321] sd 0:0:0:0: [sda] Attached SCSI disk
 
 
 Probably firmware dont support more then 2TB hard disk.
 
 orangepi plus 2  have a new firmware?
 
 Or how can i solve this problem?
 
 Thanks.
 
 
 
 
 
 
 
 
 | 
 |